Installing the Motor and Fan « Back

Insert Motor Housing into Handle, align hole in Cover with shaft of Motor and push on Motor Housing until it "locks" onto handle. (Figure 1)

To attach Fan Blade to Motor, align flat edge of Spring Clip with flat surface on motor shaft and gently press down on center of blade (along side of pring clip to let it freely fall into place) until blade can no longer be pushed onto shaft. Note: Do not press or pull on Fan Blades while handling as this can cause them to bend. (Figure 2)



Reverse steps to remove Fan and Motor assembly to clean Cover. Remove Fan Blade by lifting tab on Spring Clip until it releases from shaft, then remove blade. (Figure 2)



Newsletter Sign-up